新闻动态
路牙石模具等使用过程中的注意事项
1 .放置预制件的场地必须平整.
1. the site for prefabricating must be smooth.
2 .预制之前模具内须擦脱模剂或脱模油..
2. before the prefabrication, the mold release agent or demoulding oil must be removed.
3 .装有混凝土的模具必须放平整..
3. the mold with concrete must be leveled.
4 .禁止在4度以下预制构件..
4. prohibit prefabricated components below 4 degrees.
5 .脱模后暂时不用的模具必须在清理后摆放整齐.防止变形..
5. molds that are not used for a while after release must be laid out after cleaning.
6 .脱模时使用的敲击工具必须是木锤或皮锤..
6., percussion tools must be wooden hammers or leather hammers.
7 .脱模时要用脱模器或下面垫麻袋片或垫稻草袋或废轮胎,以防损坏预制件和模具.
The 7. release to release or mat or pad of rice straw bags or sacks of waste tires, in order to prevent damage to the preform and the mold.
8 .震动平台上要经常清理,保持平整,收工时清理干净.
8. vibration platform should always clean, neat, clean up time.
9 .预制较大构件时,若模具直接放在地上用振动棒时,振动棒头上必须套上皮套,否则可能减少模具使用寿命.
9. when prefabricated large components, if moulds are placed directly on the floor with vibrating rods, they must be covered with leather sleeves. Otherwise, the service life of dies will be reduced.
10 .预制较大构件或较重构件时容易变形,建议使用木板夹好或使用卡子或使用做好的铁框子.
10. it is easy to deform when prefabricated larger components or heavier components. It is recommended to use wooden boards to clip or use clips or use good iron frames.
11 .夏天温度较高时预制构件必须蒙上麻袋片或稻草袋或遮阳网,以防太阳晒裂预制件,并按时洒水养护.
11., when the temperature is higher in summer, prefabricated members must be covered with sack bags or straw bags or shading nets, so as to prevent the sun from cracking prefabricated parts and sprinkle water regularly.
12 .需要做带孔的预制块时所用的管子必须及时抽出,放止时间长了抽不出来.
12., when we need to make the precast blocks with holes, the pipes used must be extracted in time, and the time will not be long enough to put them out.

联系方式

  1. 保定市清苑区顺达模具销售部
  2. 电话:0312-8104188
  3. 手机:13931251644
  4. 联系人:高新
  5. 地址:河北省保定市清苑区阎庄乡南阎庄村

版权 © 保定市清苑区顺达模具销售部 网址:www.shuntianxincai.com  推荐:路牙石模具,六角护坡模具,沟盖板模具,塑料护坡模具

网站建设及优化保定遨游网络公司